News

New process solutions for battery systems manufacturing (Webinar)

Join this session at the Fall Virtual Conference on EV Engineering, presented by bdtronic, where experts in dispensing systems solutions will present new projects for manufacturing battery systems.

The focus will be on the challenges of dispensing thermal materials and foams with less waste and high-quality dispensing results. Applications in the field of battery manufacturing are, for example, gap filler injection for pouch cells or foam encapsulation of cylindrical batteries.

Reserve your spot—it’s free!


Other sessions at our Fall Virtual Conference include:

Protective Coatings for EV Electronics

Session Banner

Electronics are critical to the safety and functionality of a vehicle, but what happens if the electronics fail? The vehicle may stop unexpectedly on the interstate—or worse, overheat and cause thermal runaway. Designing a robust electronic system can prevent these scenarios from happening.

There are many factors that can cause electronics to fail, including moisture ingress, component corrosion and electrical short. Protective conformal coatings like silicone, acrylic and Parylene are some of the most commonly used in the automotive/EV market today. These coatings mitigate the risk of electronics failure and help ensure an overall robust system and passenger safety.

This session will primarily focus on the conformal coatings commonly used on electronics in power inverters, battery management systems and charging stations.

Reserve your spot—it’s free!


See the full session list for the Fall Virtual Conference on EV Engineering here.

Broadcast live on October 2-5, 2023, the conference content will span the EV engineering supply chain and ecosystem, including motor and power electronics design and manufacturing, cell development, battery systems, testing, powertrains, thermal management, circuit protection, wire and cable, EMI/EMC and more.

Products You May Like

36 Comments

Leave a Reply

Your email address will not be published. Required fields are marked *