News

Marposs offers a new system for checking pouch cell battery welds

by admin 28 Comments

Share on Facebook
Share on Twitter
Share on Pinterest
Share on LinkedIn

Marposs, a designer and manufacturer of measurement, inspection and testing products, has announced a new system for checking the welding joints of pouch cell batteries within the production process, consisting of interferometric sensors and the company’s NCG (non-contact gauge) controller. 

The system works by splitting light into two beams that travel different optical paths and are later combined to produce interference, which can identify refractive changes and surface irregularities.

Pouch cell batteries are typically sealed using impulse or contact welding (heat sealing), which fuses the plastic layers together. The thickness of this joint is a key indicator of the quality of the seal, and must be measured while the material is still soft. Marposs says its system is able to check the thickness right after the welding process using the non-contact interferometric technology.

The solution can measure thin external plastic layers starting at 1 µm and accommodate thickness variations due to the presence of the tabs in parts of the welding seam. It comes with a measuring snap with two interferometric sensors that enable the simultaneous measurement of the total thickness of the welding seam and the thickness of the two external plastic layers. Each sensor has a measuring field of 900/1.8 mm and offers a repeatability range within 1 mm of the application thickness.

Source: Marposs

This article was originally published by Chargedevs.com. Read the original article here.
Share on Facebook
Share on Twitter
Share on Pinterest
Share on LinkedIn

Products You May Like

28 Comments

Leave a Reply

Your email address will not be published. Required fields are marked *